How to Apply Your New 135 Vinyl Logo

Click on pictures to enlarge

Your brand new vinyl logo masked and ready to apply

First trim away the extra mask and backing to make the logo form to a curved surface. If you don't do this and then try to place the logo on a curved surface such as a helmet, you WILL get wrinkles.

After trimming the excess, peel away the backing and gently place the CENTER of the logo where you want it to be.

Now, gently run your finger straight up the middle of the logo to get it seated.

Gently use your finger to push the edges of the center "arms of the logo down onto the surface.

Now slowly work your way over to the side arms and gently work them down also.

After you have the logo pressed down on the surface use your finger to work your way all over the logo. Making sure to press and flatten the entire image down to the helmet. Now carefully pull the edge of the mask away. working gently and slowly.

Continue this until all the mask is removed, then slowly and gently work your finger over the entire logo again to make sure it is down solid.

If you do it right, this is what it should look like.

GOOD LUCK!!!!